Here is the abstract you requested from the IMAPS_2011 technical program page. This is the original abstract submitted by the author. Any changes to the technical content of the final manuscript published by IMAPS or the presentation that is given during the event is done by the author, not IMAPS.
|Making Sense of Laminate Dielectric Properties|
|Keywords: Laminate and Prepreg , Electrical Properties, Electrical test Methods|
|System operating speeds continue to increase as a function of the consumer demand for such technologies as faster internet connectivity, video on demand, and mobile communications technology. As a result, new high performance PCB substrates have emerged to address signal integrity issues at higher operating frequencies. These are commonly called low Dk and/or low loss (Df) materials. The published “typical” values found on a product data sheet provide limited information, usually a single construction and resin content, and are derived from a wide range of test methods and test sample configurations. A printed circuit board designer or front end application engineer must be aware that making a design decision based on the limited information found on a product data sheet can lead to errors which can delay a product launch or increase the assembled PCB cost. The purpose of this paper is to highlight critical selection factors that go beyond a typical product data sheet and explain how these factors must be considered when selecting materials for high speed applications.|
|Rich Pangier , Director OEM Marketing
Inver Grove Heights, MN